Dielle Twist Technology
The FIRST STAGE of the exchanger consists of three tubes inside which helical spirals guarantee the rotation of the water during all the passages. This detail allows the heat transfer fluid to follow a longer path and at a higher speed, thus increasing the thermal efficiency.
The SECOND STAGE of the exchanger consists of two rectangular elements, positioned to simplify cleaning. The path of the heat transfer fluid is guided by partitions to ensure that all the exchange surfaces are bathed.
Inclined heat exchangers
All exchangers are inclined in the direction of air flow to improve air expulsion and to obtain a better natural circulation in case of power failure.Air intake
All the combustion air required for combustion is taken from a single connection. Primary air, glass cleaning air and tertiary air are channelled through internal passages.This important detail makes it possible to connect the air intake to the outside so that no oxygen is burnt inside.Dual Ignition
The double combustion air inlet allows you to light the fire in the traditional way as well as to put the large wood underneath and the small one above for top lighting.Glass door
The door is the only part that remains visible when the fireplace is dressed. It is made of a single ceramic glass with silk-screen printing, resistant up to 750°, so that there are no visible painted parts that could fade or be damaged over time.Door opening
To ensure a good seal on the door, all closures are equipped with high temperature seals. The system that goes up and down is equipped with a device that, with the help of springs, presses the door on the gasket at the moment of closing to ensure a good seal over time.Glass cleaning
The new glass cleaning system draws air from the primary inlet. Thanks to special passages, it transports it to the inside of the door to create an air barrier not only on the top but also on both sides, forming a more uniform flow and keeping the glass clean for longer.
Kit Full
The Full Kit pre-installed on the fireplace stove allows the hydraulic separation of the heating circuit (closed circuit) from that of the open vessel heater. This particular system makes it possible to avoid installing the open expansion vessel of the fireplace stove at the highest point of the house because it is already on board the machine. It also makes it possible to avoid adding the power of several generators in the same system according to the requirements of current regulations.
